The Reef Tank banner
1 - 1 of 1 Posts

· Just some guy, you know?
Joined
·
40,404 Posts
I agree, you could make another 2x4 permitter that goes around the entire outside of the tank and screw it down to the existing one. I really like to put a piece of ply on top of the 2x4's and below the tank because the 2x4 joints are often not perfect, but if the joints are good it is not needed. Make sure it's flat and level and you should be fine. Another thing to consider is sheer strength, I see you have 4x4 uprights in that stand which is plenty strong, but I don't see anything that braces those at a 45 degree angle. If the stand wiggles at all it might be worth adding a support that way too.

Whiskey.
 
1 - 1 of 1 Posts
Top