The Reef Tank banner

1 - 4 of 4 Posts

·
Registered
Joined
·
236 Posts
Discussion Starter · #1 ·
I am setting up a sump system and need some over/under baffles cut. Anyone local up for the task?
 

·
Registered
Joined
·
236 Posts
Discussion Starter · #3 ·
I emailed him a while back and he said he was too busy to take anything else on.

Thanks for the suggestion though!

Anyone else have the stuff to do this? I have the sheets, I just need them cut.
 

·
TCMAS Member
Joined
·
5,667 Posts
A1 acrylics in Osseo will cut them for you I think it's $10. Only problem is they are only open on weekdays until 5pm. So likely would have to take some time off to do it. Any ole' tablesaw will work as long as it has a 40tooth carbide blade on it.
 
1 - 4 of 4 Posts
Top