The Reef Tank banner

1 - 11 of 11 Posts

·
Registered
Joined
·
874 Posts
Discussion Starter #1
so i decided to break my mag pump cover ( not reaally) and I was wondering if anyone had one laying around or know a good place to get them at, it's for a MAG3 thanks.

Lee - glxtrix
 

·
Registered
Joined
·
168 Posts
yeah i cracked mine too i went to the danner mfg. website and ordered a new one it only took three days.

www.dannermfg.com/magdrive.htm
 

·
Registered
Joined
·
264 Posts
Out of curiousity, how did you guys manage to break the casing? I've got a number of mags and short of a hammer or long drop, I couldn't imagine breaking the case.
 

·
Registered
Joined
·
874 Posts
Discussion Starter #4
I was messing with it and it snapped where the outlet meets the casing, then I proceeded to smash it with a hammer after it had a long drop ;)
 

·
Jr. Reef Tank Engineer
Joined
·
1,081 Posts
A mag drive pump faceplate will break pretty easily, if you over tighten a fitting that screws into the suction side of the pump. I did this once by over tightening a down-facing elbow on the suction side of a Mag 7 :doh:; it happens to the best of us :cool:

- Michael

GeorgeW said:
Out of curiousity, how did you guys manage to break the casing? I've got a number of mags and short of a hammer or long drop, I couldn't imagine breaking the case.
 
1 - 11 of 11 Posts
Top