The Reef Tank banner

1 - 6 of 6 Posts

·
Registered
Joined
·
359 Posts
Discussion Starter #1
Do these look right it looks to me like it is bent but it is not should it spin freely or should it be very tough???? I am soo pissed right now I want to trow the whloe thing in the trash been working on this for about 4 hours:angry: :angry: :angry: :angry: :angry:

the shaft is not centerd on the needle wheel

Garrett
 

·
Registered
Joined
·
2,135 Posts
that is wrong. i think it got jamed against the stopper on the shaft. its only supose to turn it agout 300 deg on the center shaft. i would pull it off the shaft and see if it broke the tab off or not. it should spin freely but not too freely. it should fit tight.
 

·
Registered
Joined
·
359 Posts
Discussion Starter #5
I took it off the shaft but I am not sure what I am looking for I see it looks like the needle wheel has been cut???and there is a tab on the shaft and there also is one on the wheel ...oh hell I don't know but I think Dirk will make it right with me???LOL
 
1 - 6 of 6 Posts
Top