[3Twenty5]

Stupid question, how do I take teh end caps apart to attach wiring, I have the 3 pieces apart but cannot figure how to insert the wires?

 

[RWD]

The wires go into the base of the endcap. You need to strip about 1/2" insulation off the wire and push it into the base. A spring-type clip will hold the wire. Bob

 

[thefatman]

the wires push in from the bottom of the endcap. there are two small holes, you wil lsee the metal contacts inside them. you jsut press the wire up through the hole and the contact will clamp the wire down.

 

[3Twenty5]

Thanks guys, I am in the middle of a quest for light, I just hooked both fans up in the canopy, now moving on to the VHO, and then will tackle the 2 - 250MH Ice Cap's All this in a a 36x18x12 Canopy