The Reef Tank banner

trim

  1. Tank Specs
    Does anybody know where I can get a top trim(frame) for a 46 gal bowfront. I have looked high and low but haven't found one. Thanks, Gene
  2. Front Trim Boards

    Front Trim Boards

    Got the front trim boards on finally. Stand is laying on its back. 25 Aug 2013
  3. Front Trim Boards

    Front Trim Boards

    Got the front trim boards on finally. Stand is laying on its back. 25 Aug 2013
  4. Front Trim Boards

    Front Trim Boards

    Got the front trim boards on finally. 25 Aug 2013
  5. Front Trim Boards

    Front Trim Boards

    Got the front trim boards on finally. 25 Aug 2013
  6. General Reef Discussion
    So, in spite of my elevated nitrates and issues getting my new protein skimmer broken in, these guys are doing well. Actually, today my green stars on the left have begun opening again. I have each type of coral on its own separate rock but, as you can see, the buttons in the middle are pretty...
  7. Reefing Equipment
    I have a 56 tall tank and im making a fuge out of an ac110 to hang off the back. The issue is the AC is 13.5" wide and the opening of the back of the tank is slightly narrower. Maybe less than a quarter inch. I feel that I can either trim a slight amount of the center brace and or the little...
  8. General Reef Discussion
    Hello Everyone, I am fortunate enough to have a too much growth problem in my 30g nano. As seen in the attached pic my Colt Coral (Cladiella sp., upper left part of the tank) is going bananas with growth, it was about a 3" specimen 8 months ago. Ditto my Waving Hand (Anthelia sp., upper...
  9. General Reef Discussion
    Just set up a 75gallon recently. Live rock, sand, water, etc is already set up. For the past couple of days we have noticed a very tiny salt build up in the same place between the glass and the trim at the base. If it is a leak, it is leaking so slowly that the water evaporates before it can...
  10. General Reef Discussion
    Hey, I asked this question in my build thread, but I don't think that would be as effective as having a sperate thread. I have my stand and canopy all but ready for stain. All I need to do is install the moulding around the base of the stand, the base of the thank, and the top of the...
Top