The Reef Tank banner
1-5 of 5 Results
  1. DIY Forum
    So a few days ago I was thinking to break down my jbj 28 to get a good cleaning and restart it. When I was doing this I realized the pumps were just behind a piece of plastic. So could i drill 2 holes about 8 inches up where the pumps are located and put 2 strainer bulkheads in that place. I'm...
  2. DIY Forum
    I just bought a hanger for my led light and the hanger was meant for an open top aquarium. My tank is an acryllic with an acryllic top that is part of the tank. All I would need to do to modify the hanger is to drill out a 1/2"X6" slit on each side on top of the tank so that the braces can just...
  3. Water movement (pumps & wavemakers)
    So I set up my first saltwater tank and I decided to get an MJ-400 (powerhead mode) just to move water around a little bit and it's a little too powerful and kicking up my sand. I was able to angle it to point at the waters surface to minimize it's impact on the sand (and for better gas...
  4. DIY Forum
    Hey everyone I am new to the Reef community, I have had a 65G reef going for 6-8 months and I am moving so I found it to be the perfect opportunity to upgrade. So I recently purchased 110G and a Aqueon Black Pine Stand. My question is has anyone ever reinforced this stand i do not feel like the...
  5. General Reef Discussion
    I always read how people will modify their skimmer. SHould i??? I'm pretty sure that i will get a pinwheel skimmer b\c that seems to be everyones favorite. but what is a venturi mod... or any other mod and should i do it?
1-5 of 5 Results