I'm quite proud of this all in all I have less than $40 in it right now in acrylic and PVC. All was CNC Machined by ME
OK here are some pics. Nothing is glued yey. Tonnight or tomorrow. I want to make absolutly sure all is right before using the weld on
Here is the whole reactor. I still need to drill the top for the recirc in and the PH probe holder.
Here is a close up of the top plate and cap
Top down. I have not decided if I will just use a 4" and 5" o-ring to seal it or cut a peice of flat rubber???
At this point this is my only issue. When I drilled and tapped I forgot about the thumb screw diameters. I will have to turn those two screws down a bit but no biggie
Here is one of "my" ideas???....
I put a 1/8" (plus a lil) groove in the base and the top for the chamber to seat into. I figure this will make a much tighter and cleaner seal. also there was no worries about the saw cut edges of the tubes. Even thou I polished the ends.... This should make foe one hell of a watertight rigid reactor!!!!
__________________
I play with water and electricty
