Quote:
Originally Posted by bluesea7
Guys,
OK. Since I have paid 30 bucks for the Weld-on #4 I will try to use it and will also buy extra lexan silicone to seal it afterward.
Thanks all for suggestions/helps.
Daniel
|
Locate your baffle plates with some non stick blue painters tape then use the needle pplicator to slowly squirt it under the bottom ll down that seem. It draws in via cappilary action. Give it time to set, then lay sump on side and do each vertical seam while it's horizontal. That should give you a nice consistant seem if you have a close fit.
You can always seam it with silicone after to ensure a good leakproof seal
