Just thought I'd post this here too:
1. This is what it will look like when done, well suppose to anyway.
2. The most important part is the 1.5" thd male by 1.5" slip. Notice the threads are "short" and not "long". This makes it assemble eaiser and much closer and the next one
3. This is how the ball sits inside. Perfect. Sits flush and blocks off the passage
4. Again what it will look like, just have to be drilled on the bottom with about 6-8 holes and in the top cap just need about 4 holes for the air to vent out. In the top half you will need some
filter floss and some charcoal and more floss. That stuff stinks really bad and I'm sure if the wife got a sniff of it, she would tell you that something must have died - or that you should lay off the beans.
http://www.thereeftank.com/forums/at...chmentid=18880
http://www.thereeftank.com/forums/at...chmentid=18881
http://www.thereeftank.com/forums/at...chmentid=18882
http://www.thereeftank.com/forums/at...chmentid=18883
