|
this should be real simple. usually the easiest thing to do is open up the case, or the area where the wire comes out, there is usually a strain release there to keep the wires from pulling out. inside there the wires are generally connected with only wire nuts. all of the wires are colour coded black, white, and green. the green will usually be mounted to the metal casing for ground. all you need to do is look on the cable and read the writing on it and get the same stuff from HD. i think on my ballast it was moisture resistant 16/3 wire. get whatever length you need. you will also need to pick up a 3 pronged male wall connector. i like the big ol orange ones. easier to fit the wire in and are secure. wire the black wire to the brass coloured screw, white wire to the silver coloured screw, and the green to the green coloured screw.
hth,
G~
__________________
Think Tanker
Friends Don't Let Friends Use Refugiums!
Reef Knowledge Impaired
"J" crowd member.
My Build Thread
|
do you need to replace the power cord to the ballast? are you extending the cord between the ballast and the bulb? 
