I am looking for someone to do some work on a glass (Oceanic) tank. I have a couple of things left to do before I change over from the 55 to the 110. The biggest is I want to drill the back of the 110 with 4 holes for a
closed loop system. Sounds easy enough right? Well there is one little issue, the tank has an acrylic plate that lines the rear of the tank, it has pulled away from the glass so I want someone to drill through the glass and the acrylic then seal the acrylic to the glass so the bulkheads do not leak. I asked one local glass shop and they said they could do it but they didn't sound too confident. I would rather have someone who deals with tanks on this one I think...... Any suggestions?
As always thanks for your input!!
Jim
