I was going to use this tank as my
frag tank, but i have decided to take down my 40 breeder since the 120 will be up in a few months, and use this as a nano.
The tank is 18*18*10 with center overflow and 1"bulkhead, with two 3/4" holes drilled.
The stand is just going to be 2*4's. 30" tall.
The sump and tank were made by
www.reefmania.net.
The sump is 18*18*12 with 3 baffles and enough room to fit the skimmer , return pump, and heater.
The skimmer is going to be the one i was using on the 40 breeder, and it is a Euro reef ES5-3 that runs like a charm.
I am using a mag 7 for return hooked up to a SCWD and then one they are attached to the bulkheads i am going to use locline "y" and that will allow me to aim the flow pretty good....i have am thinking about buying a nano tunze but not to sure.
The lighting i am a little worried about, i have a lumenarc 3, a pfo 250 ballast and a 14k hamilton bulb, just screaming at me to use them....if i raise this 12" above the tank, maybe more is that going to be ok??? i will have RO/salt which ever is needed drippin in the tank to make sure the sump is filled, and i also have 2*4" fans i am going to be running in the sump.
I am transfering everything over in a week or two.
I am going BB , and i will be adding randys 2part also, well 3part with the MG.
That should cover most of it, but what do you guys think?>>
The tank is going to be sps!
Thanx guys...i am pumped for this one
