Find Reviews and Compare Prices for:
 
 
 
 
User rating
 
4.0 (2)
 Add a review

Standard Threaded Bulkhead Fitting - 2 inch Featured

 
Standard Threaded Bulkhead Fittings 2" by . Bulkheads are available in 1/2', 1', 1-1/2', 2' threaded on front and slip on end


Price: $0 to $0 at 0 stores
Searched Standard Threaded Bulkhead Fitting - 2 inch in Reviews
 

 

very large bulkhead that isn't very sturdy

Comments these standard bulkheads are easy to find and simple to use. They dont really require any special tools and provide a way to plumb a system through the tank. You see them with almost any reef ready tank, and folks use them for plumbing closed loop flow systems as well. This two inch bulkhead is pretty large and not nearly as common as a 1" or 1.5", but they are used from time to time.


Liked about it These are cheap bulkheads that can be readily found. The standard threading allows users to plumb them in with little effort and with standard pieces of hardware. If properly installed, these should last for years and provide leak-free plumbing solutions through the tank.


Didn't like The one negative about this unit in particular is that it's not very robust. At 2", these are much more likely to sustain a higher loading that, over time, may create leaks. There are sturdier bulkheads (look up schedule 80 bulkheads) that I would be much more likely to use for a bulkhead of this size. While those other styles are going to be more expensive, for something as critical as your plumbing I think it's a small price to pay for a quality product.


Overall rating:
 
3.0
Overall satisfaction:
 
4.0
Would consider buying it again:
 
2.0

By crvz
May 31, 2010
 
Was this review helpful to you?
Yes No

Report this review
 
Price: $0 to $0
Compare Prices
at 0 stores

CLS intake Bulkhead.

Comments The Pump on my Closed loop is a Dart with a 2" intake. I actually use two of these the intake water from my aquarium the "TEE" into one to feed my pump

I do prefer the threaded versions. This can easily be removed without cutting any of the other plumbing. Then you can also reuse the bulkhead on another application.

Instillation is very easy. I make sure that all surfaces are clean and then use a little silicon grease on both sides of the seal.

They are super cheap and I usually keep a few 1" and 1.5" on have just in case of an emergency.


Liked about it Simple to install
Reusable because of the threaded interface.
Clean and attractive on the inside of the aquarium. The threaded versions also make it easy to install loc line on the inside of your tank.


Didn't like There really was nothing I did not like about these bulkheads.


Overall rating:
 
5.0
Overall satisfaction:
 
5.0
Would consider buying it again:
 
5.0

By ckusnierek
May 27, 2010
 
Was this review helpful to you?
Yes No

Report this review
 
Price: $0 to $0
Compare Prices
at 0 stores
 
 
























Something wrong in this page? Let us know!
internal use: spec489